Linux 안에 있는 VMware 에 깔린 윈도우즈에 원격접속하려면?

/etc/vmware/vmnet8/nat/nat.conf
이걸 설정하면 된다는걸 찾았습니다.

그런데 맞게 설정한듯 한데도 안되는군요.

이거 좀 봐주실분 없나요.

일단 3389 포트를 포워딩 할려는거고 궁금한건 저기 맨 앞에 gateway ip 라는거

초기값으로 192.168.18.2 라고 잡혀있는데 그게 왜 그런지 모르겠습니다.

vmware 가 깔려있는 리눅스의 ip 를 넣어봐도 안되더군요.

맨 밑에 3389 포트가 제가 추가한 부분이고요

이거 아시는분 조언을 구합니다.

# Linux NAT configuration file
[host]
# NAT gateway address
ip = 192.168.48.2

netmask = 255.255.255.0
# or ip = 192.168.48.2/24

# enable configuration; disabled by default for security reasons
#configport = 33445

# VMnet device if not specified on command line
device = /dev/vmnet8

# Allow PORT/EPRT FTP commands (they need incoming TCP stream...)
activeFTP = 1

# Allows the source to have any OUI. Turn this one if you change the OUI
# in the MAC address of your virtual machines.
#allowAnyOUI = 1

[udp]
# Timeout in seconds, 0 = no timeout, default = 60; real value might
# be up to 100% longer
timeout = 60

[incomingtcp]
# Use these with care - anyone can enter into your VM through these...

# FTP (both active and passive FTP is always enabled)
# ftp localhost 8887
#8887 = 192.168.48.128:21

# WEB (make sure that if you are using named webhosting, names point to
# your host, not to guest... And if you are forwarding port other
# than 80 make sure that your server copes with mismatched port
# number in Host: header)
# lynx http://localhost:8888
#8888 = 192.168.48.128:80

# SSH
# ssh -p 8889 root@localhost
#8889 = 192.168.48.128:22
3389 = 192.168.48.128:3389

[incomingudp]
# UDP port forwarding example
#6000 = 192.168.48.128:6001