데스크탑 debian 4.0 'etch'에서 usb 하드가 마운트가 되지 않습니다.
데스크탑에서 데비안 4.0을 사용합니다.
그리고 옥션에서 중고로 구입한 usb 30G 노트북하드를 하이레벨 포멧을 할려고 합니다.
그리고 위 중고하드의 파일시스템이 ntfs 인지 vfat인지는 잘 모르겠습니다.
그리고 부팅할 때 아래와 같이 이상한 에러 메새지가 나옵니다.
커널 컴파일을 해야 USB 하드를 사용할 수 있나요?
그렇다면 커널 컴파일 참고 사이트 좀 알려 주세요.
답변 좀 부탁드립니다.
--[ Dmesg 내용 ]----
hdb: cache flushes not supported
hdb: hdb1
Attempting manual resume
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Vendor: FUJITSU Model: MHR2030AT Rev: 0 0
Type: Direct-Access ANSI SCSI revision: 00
usb-storage: device scan complete
SCSI device sda: 58605120 512-byte hdwr sectors (30006 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 58605120 512-byte hdwr sectors (30006 MB)
sda: Write Protect is off
sda: Mode Sense: 03 00 00 00
sda: assuming drive cache: write through
sda:<6>pci_hotplug: PCI Hot Plug PCI Core version: 0.5
sd 0:0:0:0: SCSI error: return code = 0x10070000
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
sd 0:0:0:0: SCSI error: return code = 0x10070000
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
unable to read partition table
sd 0:0:0:0: Attached scsi disk sda
shpchp: Standard Hot Plug PCI Controller Driver version: 0.4
Linux agpgart interface v0.101 (c) Dave Jones
agpgart: Detected VIA Twister-K/KT133x/KM133 chipset
agpgart: AGP aperture is 64M @ 0xd0000000
parport_pc: VIA 686A/8231 detected
parport_pc: probing current configuration
parport_pc: Current parallel port base: 0x0
댓글 달기